
Developing Tests with VT System and CANoe
Delivery Format: This course is offered in Classroom or in Remote Format.
Duration: Classroom: 2 days
Remote: 14 hours
Target Group: CANoe users in the test field, VT System users
Prerequisites: CANoe experience, basic knowledge of CAPL or vTESTstudio
It is helpful to complete the CAPL Basics E-Learning. You will receive the link to the CAPL E-Learning before the course starts.
Goal: Deep understanding of VT System capabilities and application areas, planning and construction of a VT System, CANoe configuration and manual operation, and constraints to protect your hardware. The emphasis is on automated tests to use the VT System efficiently.
Agenda:
1. VT System Introduction
- Motivation
- Use cases
- Integration in CANoe
2. Setup
- Power supply concepts, VT7001 and VTC8920, ground connections
- Communication scenarios (VT System - CANoe)
- Processor modules (VT60x0)
- Communication modules (VT6x04)
- Start states, constraints, manual operation
- Firmware update, calibration, stand-alone mode
3. Measurement and Testing
- Review of CAPL and vTESTstudio
- Custom libraries for efficient tests
- VT1004 load module – concepts and features
- Automated tests for ECU outputs
- Bus bar applications
- VT2004 stimulation module – concepts and features
- Automated tests for sensor inputs
- Waveform generation
4. Other VT Modules
- Use cases
- Block diagrams and features
Dates
Start
Language
Locations
Format
Price